Opel Insignia: Tire Pressure Monitor Systems
Opel Insignia B 2018-2026 Service Manual / General Information / Tire Pressure Monitor Systems
READ NEXT:
Model Coverage, Description & Operation
MODEL COVERAGE
Model Coverage
Insignia 2011-19
Verano 2012-17
DESCRIPTION & OPERATION
NOTE: The TPMS sensor Relearn procedure must be performed after every
tire
rotation, BCM replacement, or
TPMS Reset Procedures
NOTE: The TPMS sensor Relearn procedure must be performed after every
tire
rotation, BCM replacement, or sensor replacement.
When the tire pressure monitor system detects a significant loss, or gain
Dismounting/Mounting Procedures
CAUTION: The tire should be dismounted from the wheel using the tire
changer
manufacturer's instructions. Use the following information to avoid
damage during the dismounting/mounting procedures.
NOT
SEE MORE:
Diagnostic Information and Procedures
DTC P0218
Diagnostic Instructions
Perform the Diagnostic System Check prior to using this diagnostic
procedure: Refer to Diagnostic System
Check - Vehicle
Review the description of Strategy Based Diagnosis: Refer to Strategy
Based Diagnosis
An overview of each diagnostic category can be fou
Repair Instructions
PROPELLER SHAFT REPLACEMENT
Special Tools
DT-51329 Drive Shaft Remover
GE-2619-A Slide Hammer
Equivalent regional tools:Special Tools.
Removal Procedure
1. Raise and support the vehicle.
2.
Floor Panel Tunnel Panel Front Brace(3) - Remove.
3.
Floor Panel Tunnel Panel Rear Brace(2) - Remove.
4
© 2019-2026 Copyright www.opinsb.com
