Opel Insignia: Engine Controls and Fuel - 2.0L (LTG)
Opel Insignia B 2018-2026 Service Manual / Engine / Engine Controls and Fuel - 2.0L (LTG)
- Description and Operation
- Diagnostic Information and Procedures
- Special Tools and Equipment
- Specifications, Schematic and Wiring Diagrams
READ NEXT:
Description and Operation
Camshaft Actuator System Description
Circuit/System Description
The camshaft position actuator solenoid valve - Intake and camshaft position
actuator solenoid valve -
exhaust system enables the engin
Diagnostic Information and Procedures
DTC P0010, P0013, or P2088-P2091
Diagnostic Instructions
Perform the Diagnostic System Check prior to using this diagnostic
procedure: Diagnostic
System Check - Vehicle
Review the description of
Special Tools and Equipment
SPECIAL TOOLS (DIAGNOSTIC TOOLS)
CH-34730-2C
J-34730-2C
Injector Test Lamp
CH-37287-1A
Fuel Pressure Gauge
Adapter 3/8"
CH-38641-B
J-38641-B
Diesel Fuel Quality
Tester
CH-39021-301
J-39021-301
Fuel
SEE MORE:
Description and Operation
Metric Wheel Nuts and Bolts Description
Metric Wheel Nuts And Bolts Are Identified In The Following Way:
The Wheel Nut Has The Word Metric Stamped On The Face.
The Letter M Is Stamped On The End Of The Wheel Bolt.
The Thread Sizes Of Metric Wheel Nuts And The Bolts Are Indicated By The
Followin
Rear Suspension
Specifications
FASTENER SPECIFICATIONS
Single Use Threaded Fastener/Component Tightening Specifications
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW
after removal.
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
wi
© 2019-2026 Copyright www.opinsb.com
