Opel Insignia Owners & Service Manuals

Opel Insignia: Engine Exhaust

Warning: Engine exhaust contains carbon monoxide (CO), which cannot be seen or smelled. Exposure to CO can cause unconsciousness and even death.

Exhaust may enter the vehicle if:

  • The vehicle idles in areas with poor ventilation (parking garages, tunnels, deep snow that may block underbody airflow or tail pipes).
  • The exhaust smells or sounds strange or different.
  • The exhaust system leaks due to corrosion or damage.
  • The vehicle exhaust system has been modified, damaged, or improperly repaired.
  • There are holes or openings in the vehicle body from damage or aftermarket modifications that are not completely sealed.

If unusual fumes are detected or if it is suspected that exhaust is coming into the vehicle:

  • Drive it only with the windows completely down.
  • Have the vehicle repaired immediately.

Never park the vehicle with the engine running in an enclosed area such as a garage or a building that has no fresh air ventilation.

Running the Vehicle While Parked

It is better not to park with the engine running.

If the vehicle is left with the engine running, follow the proper steps to be sure the vehicle will not move.

    READ NEXT:

     Automatic Transmission

    The mode or selected gear is shown in the instrument cluster. P : This position locks the drive wheels. It is the best position to use when starting the engine because the vehicle cannot move easily

     Brakes

    Antilock Brake System (ABS) This vehicle has an Antilock Brake System (ABS), an advanced electronic braking system that helps prevent a braking skid. When the vehicle begins to drive away, ABS checks

     Ride Control Systems

    Traction Control/Electronic Stability Control System Operation The vehicle has a Traction Control System (TCS) and StabiliTrak, an electronic stability control system. These systems help limit wheel

    SEE MORE:

     Repair Instructions

    Aluminum Wheel Porosity Repair 1. Remove The Tire And Wheel. 2. Inflate The Tire To The Pressure Stated On The Tire Placard. 3. Submerge The Tire/Wheel Into A Water Bath In Order To Locate The Leak. 4. Using A Grease Pencil, Mark The Wheel To Indicate The Leak Areas. 5. Using A Grease Pencil, M

     Repair Instructions

    Wire to Wire Repair - Steering Special Tools EL-38125-10 Splice Sleeve Crimping Tool (non GMNA) J-38125-5A Ultra Torch Special Tool J-38125-8 Splice Sleeve Crimping Tool (GMNA) For equivalent regional tools, refer to Special Tools. WARNING: In order to reduce the risk of personal injury, loss o

    © 2019-2026 Copyright www.opinsb.com