Opel Insignia Owners & Service Manuals

Opel Insignia: Special Tools and Equipment

Opel Insignia B 2018-2026 Service Manual / Transmission / Power Transfer Unit/Transfer Case - AAM / Special Tools and Equipment

SPECIAL TOOLS

DT - 113 - 2 - A

J - 03289-20

KM - 113-2-A

Holding Fixture

Power Transfer Unit/Transfer Case

DT-305-1

J-42176

KM-305-1

Driver Handle

Power Transfer Unit/Transfer Case

DT - 26941

J - 26941

Bushing and Bearing Remover - 3 - 4 in.

Power Transfer Unit/Transfer Case

DT - 29369 - 1

J - 29369 - 1

Bushing and Bearing Remover

Power Transfer Unit/Transfer Case

DT - 36842

J - 36842

Transaxle Holding Fixture

Power Transfer Unit/Transfer Case

DT - 36850

J - 36850

Transjel Lubricant

Power Transfer Unit/Transfer Case

DT-44380

J-44380

Differential Bearing Puller

Power Transfer Unit/Transfer Case

DT-45124

J-45124

Removal Bridge

Power Transfer Unit/Transfer Case

DT-45124 - 9

J-45124 - 9

Puller Leg

Power Transfer Unit/Transfer Case

DT - 51466

Seal Installer

Power Transfer Unit/Transfer Case

DT - 51467 - A

Seal Installer

Power Transfer Unit/Transfer Case

GE- 28431 - 6

J - 28431 - 6

Florescent Oil Dye - 6 1 oz.

Power Transfer Unit/Transfer Case

GE-42220

J-42220

High-Intensity Black Light Kit

Power Transfer Unit/Transfer Case

    READ NEXT:

     Shift Lock Control System

    SCHEMATIC AND WIRING DIAGRAMS SHIFT LOCK CONTROL WIRING SCHEMATICS Shift Lock Control DIAGNOSTIC INFORMATION AND PROCEDURES DTC B270A Diagnostic Instructions Perform the Diagnostic System Check pri

     Transmission Cooling System

    SPECIFICATIONS FASTENER SPECIFICATIONS Single Use Non-Threaded Fasteners/Components NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. Applicati

     Diagnostic Information and Procedures

    Transmission Overheats TRANSMISSION FLUID COOLER FLOW TEST AND FLUSHING (6T50) GM studies indicate that plugged or restricted transmission oil coolers and pipes cause insufficient transmission lubri

    SEE MORE:

     Repair Instructions - On Vehicle

    Transfer Case Fluid Replacement Removal Procedure 1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle. 2. NOTE: When performing the following procedure, use only hand tools to remove and install the drain and fill plugs. Ensure that an approved drain pan is

     Repair Instructions

    REPAIRS AND INSPECTIONS REQUIRED AFTER A COLLISION WARNING: Restraint systems can be damaged in a collision. To help avoid injury and ensure that all parts in need of replacement are replaced: Replace any seat belt system that was in use during the collision serious enough to deploy any automati

    © 2019-2026 Copyright www.opinsb.com