Opel Insignia: Transmission
Opel Insignia B 2018-2026 Service Manual / Transmission
- Automatic Transmission - Aisin AF50-8 (MRC)
- Specifications, Schematic Wiring Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Repair Instructions - On Vehicle
- Repair Instructions - Off Vehicle
- Description and Operation
- Special Tools and Equipment
- Power Transfer Unit/Transfer Case - AAM
- Specifications
- Component Locator
- Diagnostic Information and Procedures
- Repair Instructions - On Vehicle
- Repair Instructions - Off Vehicle
- Description and Operation
- Special Tools and Equipment
- Shift Lock Control System
- Transmission Cooling System
READ NEXT:
Specifications, Schematic Wiring Diagrams
Specifications
FASTENER SPECIFICATIONS (OFF VEHICLE)
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW
after rem
Component Locator
DISASSEMBLED VIEWS
Case and Associated Parts (1 of 2)
Transmission Control Module Bolt [3x]
Transmission Control Module
Manual Shift Shaft Seal
Transmission Fluid Filler Tube Plug
Transmission
SEE MORE:
Repair Instructions
PROPELLER SHAFT REPLACEMENT
Special Tools
DT-51329 Drive Shaft Remover
GE-2619-A Slide Hammer
Equivalent regional tools:Special Tools.
Removal Procedure
1. Raise and support the vehicle.
2.
Floor Panel Tunnel Panel Front Brace(3) - Remove.
3.
Floor Panel Tunnel Panel Rear Brace(2) - Remove.
4
Description and Operation
Turbocharger System Description
Turbocharger Description and Operation
A turbocharger is a compressor that is used to increase the power output of
an engine by increasing the mass of the
oxygen and therefore the fuel entering the engine. A turbocharger is mounted
either to the exhaust manifold or
© 2019-2026 Copyright www.opinsb.com
