Opel Insignia: Automatic Transmission - Aisin AF50-8 (MRC)
Opel Insignia B 2018-2026 Service Manual / Transmission / Automatic Transmission - Aisin AF50-8 (MRC)
- Specifications, Schematic Wiring Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Repair Instructions - On Vehicle
- Repair Instructions - Off Vehicle
- Description and Operation
- Special Tools and Equipment
READ NEXT:
Specifications, Schematic Wiring Diagrams
Specifications
FASTENER SPECIFICATIONS (OFF VEHICLE)
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW
after rem
Component Locator
DISASSEMBLED VIEWS
Case and Associated Parts (1 of 2)
Transmission Control Module Bolt [3x]
Transmission Control Module
Manual Shift Shaft Seal
Transmission Fluid Filler Tube Plug
Transmission
Diagnostic Information and Procedures
DTC P0218
Diagnostic Instructions
Perform the Diagnostic System Check prior to using this diagnostic
procedure: Refer to Diagnostic System
Check - Vehicle
Review the description of Strategy Base
SEE MORE:
Repair Instructions - Off Vehicle
Power Transfer Unit Case Disassemble
Power Transfer Unit Case Holding Fixture Installation
Power Transfer Unit Case
Procedure
Always secure with the pivot pin after rotating.
NOTE:
The power transfer unit can be rotated 360 degrees to facilitate repair.
Special Tools
DT-3289-20 Holding
Performance and Maintenance
Traction Control/Electronic
Stability Control
The Traction Control System (TCS)
limits wheel slip. The system turns
on automatically every time the
vehicle is started.
The StabiliTrak system assists with
directional control of the vehicle in
difficult driving conditions. The
system turns on automat
© 2019-2026 Copyright www.opinsb.com
