Opel Insignia: Special Tools and Equipment
Opel Insignia B 2018-2026 Service Manual / Transmission / Automatic Transmission - Aisin AF50-8 (MRC) / Special Tools and Equipment
SPECIAL TOOLS
DT-26941
J-26941
Remover
DT-37228
J-37228
Seal Cutter
DT-43911
J-43911
Selector Shaft Seal Remover
DT-44215
J-44215
Rear Seal Installer
DT-44809
J-44809
Output Shaft Seal Installer
DT-45124
J-45124
Removal Bridge
DT-45124-9
J-45124-9
Puller Leg
DT-47865
Bearing Remover
DT-48056
Spring Compressor Bridge
DT-48903
Spring Compressor
DT-49101
Seal Installer
DT-50298
Axle Seal Installer
DT-51721
Bearing Race Installer
DT-51918
Bearing Race Installer
DT-51919
Bearing Race Remover
DT-51920
Clutch Spring Compressor
EN-21867
J-21867
Pressure Gauge
EN-21867-50
J-21867-50
Transmission Line Pressure Adapter
EN-45000
J-45000
Seal Remover
GE-6125-1B
J-6125-1B
Slide Hammer with Adapter
GE-8092
J-8092
Driver Handle
READ NEXT:
Specifications
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW
after removal.
Application
Power Trans
Component Locator
POWER TRANSFER UNIT CASE DISASSEMBLED VIEW
Power Transfer Unit Components
Power Transfer Unit Alignment Sleeve
Power Transfer Unit Face Seal - O-Ring
Power Transfer Unit Case
Power Transfer Unit
SEE MORE:
Electrical System
Electrical System Overload
The vehicle has fuses and circuit
breakers to protect against an
electrical system overload.
When the current electrical load is
too heavy, the circuit breaker opens
and closes, protecting the circuit
until the current load returns to
normal or the problem is fixed. This
HVAC - Automatic
SPECIFICATIONS
FASTENER TIGHTENING TORQUE SPECIFICATIONS
Reusable Threaded Fastener Tightening Specifications
NOTE:
All fasteners listed in this table can be reused after removal.
SCHEMATIC WIRING DIAGRAMS
HVAC WIRING SCHEMATICS
HVAC Module Power, Ground, Serial Data, and Subsystem References
HVAC
© 2019-2026 Copyright www.opinsb.com
