Opel Insignia: Wheel Drive Shafts
Opel Insignia B 2018-2026 Service Manual / Steering & Driveline & Axle / Wheel Drive Shafts
READ NEXT:
Specifications, Diagnostic Information and Procedures
SPECIFICATIONS
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW
after removal.
Applicat
Repair Instructions
Front Wheel Drive Intermediate Shaft Replacement
Removal Procedure
1. Remove the tire and wheel assembly.
WARNING: To prevent personal injury and/or component damage, do not
allow the weight
of the v
Description and Operation
WHEEL DRIVE SHAFTS DESCRIPTION AND OPERATION
Wheel drive shafts are flexible assemblies consisting of an inner joint and
an outer constant velocity joint connected
by an axle shaft. The inner joint i
SEE MORE:
Repair Instructions
PROPELLER SHAFT REPLACEMENT
Special Tools
DT-51329 Drive Shaft Remover
GE-2619-A Slide Hammer
Equivalent regional tools:Special Tools.
Removal Procedure
1. Raise and support the vehicle.
2.
Floor Panel Tunnel Panel Front Brace(3) - Remove.
3.
Floor Panel Tunnel Panel Rear Brace(2) - Remove.
4
Conversions and Add-Ons
Add-On Electrical
Equipment
Warning:
The Data Link Connector (DLC) is
used for vehicle service and
Emission Inspection/Maintenance
testing. See Malfunction
Indicator Lamp (Check Engine
Light). A device connected
to the DLC - such as an
aftermarket fleet or
driver-behavior tracking device -
may inter
© 2019-2026 Copyright www.opinsb.com
