Opel Insignia: Steering & Driveline & Axle
Opel Insignia B 2018-2026 Service Manual / Steering & Driveline & Axle
- Power Steering
- Specifications, Schematic and Wiring Diagrams
- Diagnostic Information and Procedures
- Repair Instructions
- Description and Operation
- Steering Wheel and Column
- Propeller Shaft
- Rear Drive Axle
- Wheel Drive Shafts
READ NEXT:
Specifications, Schematic and Wiring Diagrams
SPECIFICATIONS
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW after removal.
Applicati
Diagnostic Information and Procedures
DTC C0176
Diagnostic Instructions
Perform the Diagnostic System Check prior to using this diagnostic
procedure:Diagnostic System
Check - Vehicle
Review the description of Strategy Based Diagnosi
SEE MORE:
Special Tools and Equipment
SPECIAL TOOLS
DT-26941
J-26941
Remover
DT-37228
J-37228
Seal Cutter
DT-43911
J-43911
Selector Shaft Seal
Remover
DT-44215
J-44215
Rear Seal Installer
DT-44809
J-44809
Output Shaft Seal
Installer
DT-45124
J-45124
Removal Bridge
DT-45124-9
J-45124-9
Puller Leg
DT-47865
Bearing Remover
DT-48056
Repair Instructions
Aluminum Wheel Porosity Repair
1. Remove The Tire And Wheel.
2. Inflate The Tire To The Pressure Stated On The Tire Placard.
3. Submerge The Tire/Wheel Into A Water Bath In Order To Locate The Leak.
4. Using A Grease Pencil, Mark The Wheel To Indicate The Leak Areas.
5. Using A Grease Pencil, M
© 2019-2026 Copyright www.opinsb.com
