Opel Insignia: Immobilizer
Opel Insignia B 2018-2026 Service Manual / Accessories and Equipment / Immobilizer
SCHEMATIC AND WIRING DIAGRAMS
IMMOBILIZER WIRING SCHEMATICS
Immobilizer
.png)
READ NEXT:
Diagnostic Information and Procedures
DTC B2955 (with BTM)
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this
diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnos
Repair Instructions
Theft Deterrent Module Replacement
Preliminary Procedure
Front Floor Console Replacement.
Theft Deterrent Module
Procedure
Disconnect the electrical connector.
Control Module References for pr
Description and Operation
IMMOBILIZER DESCRIPTION AND OPERATION
Without BTM
The immobilizer system functions are provided by the Immobilizer Control
Module, the Body Control
Module (BCM) and the Engine Control Module (ECM),
SEE MORE:
Specifications, Diagnostic Information and Procedures
SPECIFICATIONS
FASTENER SPECIFICATIONS
Single Use Non-Threaded Fasteners/Components
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced
with NEW
after removal.
Application
O-Ring at PTU Output Shaft
O-Ring at Rear Differential Input Shaft
Retaining Ring at PTU Output
Description and Operation
CAMBER DESCRIPTION
Camber is the tilting of the wheels from the vertical when viewed from the
front of the vehicle. When the
wheels tilt outward at the top, the camber is positive (+). When the wheel tilts
inward at the top, the camber
is negative (-). The amount of tilt is measured in degrees fr
© 2019-2026 Copyright www.opinsb.com
